Introduction
When it comes to lighting up your home, there are many options available in the market. From sophisticated chandeliers to elegant table lamps, each lighting fixture has its charm. However, if you are a beginner and just beginning to explore the world of lighting fixtures, it is best to start with basic light fitting.
What is Basic Light Fitting?
Basic light fitting is the process of attaching a light fixture to a ceiling or wall. A light fitting can be anything from a simple pendant light to a flush-mounted ceiling light.
Tools Required for Basic Light Fitting
Before you start the installation process, you must have the following tools:
- Wire stripper
- Electrical screwdriver
- Electric drill with a 6mm or 8mm masonry bit, depending on the wall type.
- Wire nuts
- Hammer
- Nose plier
- Cable ties
Steps for Basic Light Fitting
Now let’s dive into the installation process.
- Switch OFF the Electric Supply – Before starting the installation process, turn OFF the electric supply for safety. You can do this by flipping the switch on the distribution board.
- Choose the Location – Decide the location where you want to install the light fixture. You can use a stud finder to locate the studs on which you will mount the fixture.
- Mark the Drilling Points – Once you have decided the location, use screws and an L-bracket to mark the drilling points. Use a pencil to mark the drilling point on the wall.
- Drill the Holes – With the help of an electric drill, drill the holes on the marked points. Make sure you use the appropriate drill bit size that matches your light fixture.
- Thread the Wire – Thread the wire from the fixture through the hole and secure it in place with cable ties.
- Connect the Wires – Connect the wires from the light fixture to the wires from the ceiling or wall. Use wire nuts and nose pliers to hold the wires securely in place.
- Mount the Fixture – Now that the wiring is complete, you can mount the fixture to the wall or ceiling. Insert the screws into the holes and use a hammer and screwdriver to fix the fixture securely in place.
- Switch ON the Electric Supply – Finally, switch ON the electrical supply and turn ON the light to test the installation.
Conclusion
Basic light fitting is a simple DIY project that can save your money and brighten up your home. By following the steps mentioned above and using the right tools, you can install basic light fixtures in a matter of hours. However, if you are not confident about the installation process, it is best to seek assistance from a professional electrician.